Login |
Main Gallery » Projects » 2510p SATA caddy » Top and rear metal plates from caddy removed to expose LED and connector. This is the top side view.

Actions

2510p SATA caddy

1. Package... ... 17. DVD rear... 18. Caddy metal... 19. Metal guide... 20. Top and... 21. Bottom view... 22. Top view of... 23. 2510p bios ... ... 50. WD3200BEKT_...
 
 
 
Top and rear metal plates from caddy removed to expose LED and connector. This is the top side view.
 
 
Close-up of original caddy PATA connector. Remove 2 screw and pull off board to expose the required 2510p connector. PATA connector board removed from caddy Close-up of the correct 2510p PATA connector below. DVD optical drive above.
DVD side screw bracket that needs to be transfered to caddy DVD rear screw bracket that needs to be transfered to caddy Caddy metal guide that needs to be removed so caddy will fit.
Metal guide removed after unscrewing 2 screws Top and rear metal plates from caddy removed to expose LED and connector. This is the top side view. Bottom view of caddy circuit board.
Top view of caddy circuit board displaying Marvel PATA to SATA chip. 2510p bios shot of installed caddy being recognized as a "Notebook Multibay" device. Bottom gap between caddy faceplate and 2510p chasis
Close up of gap Caddy front plate. Non-angled front plate on bottom right which is not flush with 2510p chasis. Installing WinXP from a USB drive. Set Bios or boot menu to boot from USB-HDD first.

Top and rear metal plates from caddy removed to expose LED and connector. This is the top side view.

Date: 07/18/2009
81 KB

Exif
Powered by Gallery v2.3